Cable the Router
Grounding the Router
This section provides instructions for grounding the router.
1 | Insulated cable | A | 1/4″ |
2 | Heat-shrink tubing | B | 1/2″ |
3 | Lug | C | 5/8″ |
Connecting Power Cables
Power cords are optional and must ordered separately. You must use an approved power cord that is compliant with local and national electrical codes or order one from Arista for use with this device.
Installation of this equipment must comply with local and national electrical codes. Consult with the appropriate regulatory agencies and inspection authorities to ensure compliance.
Installation de cet équipement doit être conformes aux codes électriques locaux et nationaux. Si nécessaire, consulter les organismes de réglementation appropriés et des autorités de contrôle pour assurer la conformité.
- Non-redundant configuration: Connect power to either of the two power supplies.
- Redundant power supply configuration: Connect power to both power supplies.
- Turn off the router: Remove all power cords and wires from the power supplies.
The installation of this equipment must comply with local and national electrical codes. Consult with the appropriate regulatory agencies and inspection authorities to ensure compliance.
Installation de cet équipement doit être conformes aux codes électriques locaux et nationaux. Si nécessaire, consulter les organismes de réglementation appropriés et des autorités de contrôle pour assurer la conformité.
Read all installation instructions before connecting the system to the power source.
Lire toutes les instructions d’installation avant de brancher le système à la source d’alimentation.
This equipment must be grounded. Never defeat the ground conductor.
Cet équipement doit être mis à la terre. Ne jamais modifier le conducteur de terre.
This unit requires overcurrent protection.
Cet appareil requiert une protection contre les surintensités.
AC Power Supplies
- PWR-00619-01 (AWE-7230R-4TX-4S)
- PWR-00618-01 (AWE-7250R-16S)
The following image displays an AC power supply, including the power socket on the left side of the module. The AC power supply connects to a circuit that provides the required power, as specified in the Specifications section.
The power supplies require cables that comply with IEC-320 and have a C14 connector. The accessory kit provides two IEC-320 C13 to C14 power cables.
Connecting Serial and Management Cables
- RJ45 to DB9 serial adapter cable
- RJ45 Ethernet cable
The following table lists the pin connections of the RJ45 to DB9 adapter cable.
RJ45 |
DB9 |
RJ45 |
DB9 |
|||||
---|---|---|---|---|---|---|---|---|
RTS | 1 | 8 | CTS | GND | 5 | 5 | GND | |
DTR | 2 | 6 | DSR | RXD | 6 | 3 | TXD | |
TXD | 3 | 2 | RXD | DSR | 7 | 4 | DTR | |
GND | 4 | 5 | GND | CTS | 8 | 7 | RTS |
- Console (serial) port: Connect to a computer with the RJ45 to DB9 serial adapter cable. The router uses the following default settings:
- 9600 baud
- No flow control
- 1 stop bit
- No parity bits
- 8 data bits
- Ethernet management port: Connect to 10/100/1000 management network with RJ45 Ethernet cable.
- USB port: The two USB ports (Type-A and Type-C) may be used for software or configuration updates.
CAUTION:
Excessive bending can damage interface cables.
Flexion excessive peut endommager les câbles d’interface.