- Written by Shelly Chang
- Posted on 1月 6, 2022
- Updated on 5月 3, 2024
- 7655 Views
This feature introduces hardware forwarding support of IPv4 multicast traffic over IPv4 GRE tunnel interfaces in Arista Switches. Multicast source traffic can reach the receivers which are separated by an IP cloud which is not configured for IP multicast routing by utilizing a GRE tunnel.
- Written by James Brinkley
- Posted on 4月 25, 2022
- Updated on 1月 5, 2023
- 8599 Views
SWIM (SWI Modularized) is a change to the format of EOS.swi. It is a feature that is mostly internal, but has a few customer visible side-effects one should be mindful of.
- Written by Prasanna Parthasarathy
- Posted on 12月 23, 2021
- Updated on 7月 12, 2024
- 12306 Views
SwitchApp is an FPGA-based feature available on Arista’s 7130LB-Series and 7132LB-Series platforms. It performs ultra low latency Ethernet packet switching. Its packet switching feature set, port count, and port to port latency are a function of the selected SwitchApp profile. Detailed latency measurements are available in the userguide on the Arista Support site.
- Written by Vishrant Vasavada
- Posted on 1月 3, 2023
- Updated on 5月 21, 2024
- 3593 Views
The new show command show configuration consistency adds the ability to check for “dangling” references in the configuration. For example, it is possible to configure an access-list, TEST-ACL, to an interface (ip access-group TEST-ACL in), without actually defining TEST-ACL (ip access-list TEST-ACL). This show command will list such “undefined” references.
- Written by Anirudh Ramesh Iyer
- Posted on 5月 5, 2021
- Updated on 7月 19, 2024
- 15819 Views
This article describes how to customize TCAM ( Ternary Content Addressable Memory ) lookup for each feature which uses TCAM.
- Written by Isidor Kouvelas
- Posted on 2月 28, 2022
- Updated on 7月 29, 2024
- 13250 Views
Virtual Private LAN Service (VPLS) appears in (almost) all respects as an Ethernet type service to customers of a Service Provider (SP). A VPLS glues together several individual LANs across a packet switched network to appear and function as a single bridged LAN. This is accomplished by incorporating MAC address learning, flooding, and forwarding functions in the context of pseudowires that connect these individual LANs across the packet switched network. LDP signaling is used for the setup and teardown of the mesh of pseudowires that constitute a given VPLS instance.
- Written by Simon Liang
- Posted on 9月 5, 2021
- Updated on 5月 30, 2024
- 8023 Views
This document describes the VRF selection policy and VRF fallback feature. A VRF selection policy contains match rules that specify certain criteria (e.g. DSCP, IP protocol) as well as a resulting action to select a VRF in which to do the FIB lookup. The VRF fallback feature is an extension of these policies which allows users to optionally specify a “fallback” VRF for each VRF. The behavior is such that if the FIB lookup fails in a match rule’s selected VRF, another lookup will be attempted in the configured fallback VRF. Additionally, the fallback VRF itself can have yet another fallback VRF, such that if the lookup in the VRF and fallback VRF fail, the fallback-of-the-fallback VRF will be looked up (see the Configuration section for an example of this).