Total 8 results found for the keyword of "eos 7130 layer 1 configuration"
7130 Platform layer 1 configuration
This section describes the purpose, behavior, and configuration of the 7130 platform and includes the following topics:
Configuring layer 1 on 7130 Platform
Interface ...
... Considerations
The following information should be considered when using the L1 source suite of commands:
eos only enforces speed mismatch on Ethernet ...
7130 layer 1 Commands
layer 1 configuration Commands
l1 source
layer 1 Show Commands
show l1 destination
show l1 matrix
show l1 path
show l1 source
show l1 source
capabilities
l1 ...
layer 2 Protocol Forwarding
eos supports layer2 (L2) Protocol Forwarding on Ethernet interfaces in addition to
Type-5 PW. Also, eos allows selective forwarding of certain L2 Protocol packets, such ...
... offers an echo function. eos supports
asynchronous mode and the echo function.
Asynchronous Mode
Demand Mode
Asynchronous Mode
In asynchronous mode, BFD control packets are exchanged by neighboring ...
Quality of Service
This chapter describes the eos Quality of Service (QoS) implementation, including configuration instructions and command descriptions. Topics covered by this chapter include ...
...
Note: In eos releases prior to 4.23.2, this command identified system peers
with IPv6 addresses by their reference IDs (the first four octets of the MD5 hash of
the IPv6 address). In later releases, ...
...
eos disables PTP globally by default. Enabling PTP on an interface requires the following steps:
Setting the PTP
Mode
Enabling
PTP on an Interface
Optional PTP global configurations include the ...