Total 10 results found for the keyword of "eos section 16 3 tap aggregation configuration"
... timestamp
Drop count
Device ID
Egress
interface
FCS type
Reserved
tap aggregation Extra MPLS Pop (4 to 6 Labels)
Available starting with eos Release 4.23.1F extra MPLS pop for tap
aggregation ...
... The default mode of operation is All-active. Introduced in the
eos 4.26.0F for VXLAN, singe-active is another mode of
operation in which only one PE per VLAN accepts traffic for that Ethernet
segment. ...
7130 Platform Layer 1 configuration
This section describes the purpose, behavior, and configuration of the 7130 platform and includes the following topics:
Configuring Layer 1 on 7130 Platform
Interface ...
...
sFlow exports packet samples and topology meta data to a centralized collector
application.
sFlow scales and operates on all switch ports simultaneously.
eos implements sFlow on all switches, without ...
... ssh
switch(config-mgmt-ssh)# ip access-group [vrf ] inswitch(config-mgmt-ssh)#ipv6 access-group [vrf ] in
In Release eos-4.19.0, all VRFs are required to use the same SSH server
Service ACL. The Service ...
... that are configured by a custom agent using the eos SDK or eAPI
and age out (expire) after a specified time period.
For example, if you are using a custom agent that reacts to traffic sent to the CPU ...
... configuration
Procedures
VLAN configuration
Commands
VLAN Introduction
Arista switches support industry standard 802.1q VLANs. Arista eos provides tools to manage and extend VLANs throughout the ...
... enables delaying proxy ARP requests on the configuration mode
interface. eos disables Proxy ARP by default. When enabled, the switch
responds to all ARP requests, including gratuitous ARP requests, with ...
... command for shutting down the Tx output path for unidirectional
mode.
1-second update of pre-FEC BER, OSNR, ESNR.
Support of the 4x100 Gb/s mode for the 400GBASE-ZR transceivers (eos
release 4.25.2F). ...
... Mac Address Type Ports
---- ----------- ---- -----
Total Mac Addresses for this criterion: 0
Beginning with eos Release 4.26.0F,
PortSec-Protect enforces a limit on ...