Total 5 results found for the keyword of "wap c460 connect the access point to the network"
connecting the access point to the network To connect the AP to the network, perform the following steps: Be sure to install the AP on a network with a DHCP-enabled server. Set up a DNS entry ...
AP-Server Mutual Authentication the AP-server communication begins with a mutual authentication step where the AP and server authenticate each other using a shared secret. If this authentication ...
Powering the access point On Power the access point (AP) on by plugging one end of the Ethernet cable into the Power over Ethernet++ (PoE++) switch or injector and the other end into the Ethernet/PoE++ ...
Installing the access point This section contains the procedure to install the access point (AP). Zero-Configuration of the access point the AP supports zero-configuration under the following ...
access point Troubleshooting the table below lists some of the access point (AP) troubleshooting guidelines.     Problem Solution the AP did not receive a valid IP address via ...