Total 11 results found for the keyword of "eos section 12 3 port channel configuration procedures"
... (also configured as a dynamic LAG) on the partner switch. The maximum number of ports per LAG varies by platform; numbers for each platform in the latest eos release are available here: https://www.arista.com/en/support/product-documentation/supported-features. ...
... command for shutting down Tx output path for unidirectional mode
1-sec update of pre-FEC BER, OSNR, ESNR
Support of 4x100G mode for the 400GBASE-ZR transceivers (eos release 4.25.2F)
Support of 400GBASE-ZR ...
VM Tracer
This chapter describes VM Tracer configuration and usage and contains these sections:
Introducing VM Tracer
VM Tracer Description
VM Tracer configuration procedures
VM Tracer ...
Multicast Source Discovery Protocol (MSDP)
Multicast Source Discovery
Protocol (MSDP) describes a topology that connects multiple IPv4 Protocol
Independent Multicast Sparse-Mode (PIM-SM) domains. ...
... and destination
addresses..
ACLs can also be made dynamic (not persisting in the eos), and the
payload keyword can be used to
turn an ACL into a User-Defined Field (UDF) alias for use in other ACLs. ...
VRRP and VARP
A virtual IP (VIP) address
is an IP address that does not directly connect to a specific interface.
Inbound packets sent to a Virtual IP address are redirected to a physical
network ...
... configuration
procedures
VLAN configuration
Commands
VLAN Introduction
Arista switches support industry standard 802.1q VLANs. Arista eos provides tools to manage and extend VLANs throughout the ...
... Type ports
---- ----------- ---- -----
Total Mac Addresses for this criterion: 0
Beginning with eos Release 4.26.0F,
portSec-Protect enforces a limit on the number of MAC
addresses, ...
... - Chassis ID type: MAC address (4)
Chassis ID : 001c.730f.11a8
- System Name: "switch.aristanetworks.com"
- System Description: "Arista Networks eos version 4.13.2F running on an Arista
Networks ...
...
eos is optimized to support QoS configuration on the Fabric interfaces on 7250x and 7300 series switches. Configuring QoS on the Fabric interfaces in addition to front panel ports allows user to have ...
... 32-bit
integer used in the candidate path selection
algorithm to select the “active” candidate path.
The default value for preference is
100.
Binding SID (BSID): an optional,
SID.Note: In eos, a BSID ...