Total 50 results found for the keyword of "eos section 21 3 vxlan configuration"
... STP state. When an interface used as an Ethernet segment does not have a forwarding
state, eos considers the interface to be inactive. For a VLAN-based service, the port must be in a forwarding state
on ...
Sample configurations
EVPN vxlan IRB Sample configuration
In the following topology, we are connecting a Layer 2 site with a Layer 3 site using Layer
3 EVPN (type-5 route). The right side leaves ...
... router-mac ba:ed:43:3f:ca:8e
MLAG
This feature applies only to the scenario when two different MLAG VTEP pairs learn the
remote prefix.
Prior to 4.26.0F, eos supports this feature on the primary ...
vxlan DSCP Mapping
vxlan DSCP Mapping allows the selection of Differentiated Services Code Point
DSCP and Traffic Class TC values for packets
at VTEPs ( vxlan Tunnel Endpoint) along vxlan encapsulation ...
... that use vxlan encapsulation support the E-Tree
extended community, and deployments using MPLS encapsulation must use asymmetric route
targets.
When implementing a single route-target E-Tree, eos supports ...
EVPN vxlan Single-Gateway Centralized Routing
In a traditional EVPN vxlan centralized anycast gateway deployment, multiple L3 VTEPs
serve the role of the centralized anycast gateway. For the hosts ...
Virtual Extensible LANs (vxlans)
This chapter describes Arista’s Virtual Extensible LAN (vxlan)
implementation. sections in this chapter include:
vxlan Introduction
vxlan Description
vxlan configuration ...
vxlan Description
These sections describe vxlan architecture, the data objects that comprise a vxlan network, and
process of bridging packets through a vxlan network.
vxlan Architecture
vxlan Gateway ...
vxlan Commands
vxlan Global configuration
Commands
interface vxlan
ip address virtual
vxlan vni notation
dotted
vxlan Interface configuration
Commands
vxlan flood vtep
vxlan multicast-group ...
...
sFlow exports packet samples and topology meta data to a centralized collector
application.
sFlow scales and operates on all switch ports simultaneously.
eos implements sFlow on all switches, without ...
... manager can request or change. The agent gathers data from the MIB and responds to requests for information. For a list of supported MIBs, refer to the release notes for the specific eos version.
This ...
VM Tracer
This chapter describes VM Tracer configuration and usage and contains these sections:
Introducing VM Tracer
VM Tracer Description
VM Tracer configuration Procedures
VM Tracer Commands ...
LDP Pseudowire
LDP pseudowire provides support for emulating Ethernet connections over a
Multiprotocol Label Switching (MPLS) network, and controlled using the extension of the MPLS
Label Distribution ...
...
Examples
In this example, eos sends hello messages to all known neighbors every
10 seconds. If the switch does not receive
hello responsesfrom a neighbor for 4*10=40 seconds, the switch loses
communication ...
... timestamp
Drop count
Device ID
Egress
interface
FCS type
Reserved
TAP Aggregation Extra MPLS Pop (4 to 6 Labels)
Available starting with eos Release 4.23.1F extra MPLS pop for TAP
Aggregation ...
... template interval 3400000
Hardware Flow Tracking with IPFIX Export
Hardware Flow Tracking uses match criteria to collect data from packets based on defined
flow profiles. eos sends the collected ...
Inter-VRF Local Route Leaking
Inter-VRF local route leaking allows the leaking of routes from one VRF (the source VRF) to
another VRF (the destination VRF) on the same router.
Inter-VRF routes can ...
EVPN Multicast VRF Leaking
Overview
EVPN Multicast virtual routing and forwarding (VRF) Leaking forwards multicast
traffic from a sender in a tenant or external domain (VRF) to a different domain
(VRF) ...
VCS to EVPN Hitless Migration
VCS to EVPN Hitless Migration enables support for migrating from only using VCS as
the control plane to only using EVPN as a control plane in a hitless manner concerning ...
...
eos adds a new parameter in the output, evpn prefix detail to display the
ATTR_SET, code 128 attributes.
switch#show bgp evpn
BGP routing table information for VRF default
Router identifier 10.11.0.1, ...