- Written by Phillip Jie
- Posted on April 16, 2020
- Updated on April 16, 2020
- 5560 Views
This article describes the support for specifying User Defined Fields (UDF) in Sub interface ACLs including IPv4 and
- Written by Anitha Muppalla
- Posted on May 15, 2020
- Updated on September 28, 2023
- 6725 Views
Subinterfaces divide a single ethernet or port channel interface into multiple logical L2 or L3 interfaces based on the 802.1q or 802.1ad tags of incoming traffic. Subinterfaces are commonly used in the L2/L3 boundary device, but they can also be used to isolate traffic with 802.1q tags between L3 peers by assigning subinterfaces to different VRFs or different L2 bridging domains.
- Written by Sandeep Betha
- Posted on April 21, 2020
- Updated on April 27, 2020
- 7053 Views
In the ribd routing protocol model, the “maximum paths … ecmp …” command allows restricting the number of BGP
- Written by Travis Hammond
- Posted on April 24, 2020
- Updated on January 17, 2022
- 6061 Views
TAP Aggregation support for the DCS 7280R3 and DCS 7500R3 series is documented below, including the release in which a
- Written by Vipul Shah
- Posted on August 27, 2019
- Updated on November 23, 2023
- 6371 Views
BGP routing information often contains more than one path to the same destination network. The BGP best-path selection algorithm determines which of these paths should be considered as the best path to that network.
- Written by Satish Kumar Selvaraj
- Posted on April 20, 2020
- Updated on December 9, 2021
- 5299 Views
TCB provides a mechanism to capture information around a MMU(Memory management unit) drop event.
- Written by Neel Neogi
- Posted on December 19, 2019
- Updated on December 21, 2021
- 7637 Views
Two rate three color marker (TrTCM) meters an incoming packet stream and marks the packets based on two rates, PIR