Powering on the Access Point

Plug one end of the Ethernet cable into the PoE++ switch or compatible PoE injector, a Single-port High Power Midspan, 802.3bt compliant, up to 5Gigabit PoE with PD54V in power output, and the other end into the LAN1 (PoE++) on the AP. Be sure to turn on the PoE++ source. Use an active wrench with a 27 mm opening to open the LAN (PoE++) port cap.

The access point (AP) package must contain the components shown in the following figure.
Figure 1. Use Active Wrench
Use an active wrench to open the LAN cap.
Table 1. Labels: Measurements
Label Description
1 The LAN port cap has a width of 27mm.
2 Use an active wrench to open the LAN port cap.
3 Insert LAN cable.

Earthing or Grounding: The AP must be properly grounded using a copper grounding wire (12 ~ 10 AWG) and a tin-plated lug as shown in the following image. The wire and the lug must be tightened at the grounding screw on the AP.

Note: Connect the power cord of the power adapter, if used, to a socket outlet with an grounding connection.

The following two images show the position of the grounding screw on the AP, displayed as 1, and the dimension of the lug that attaches to the grounding screw.

Figure 2. Position of the Grounding Screw on the AP
Figure 3. Lug Nut Dimension
Note: The O-435E APs requires a UL-listed PoE+ power source suitable for use at 65 degree Celsius with an output that meets LPS requirements or PS2, with a rating of 54V DC (0.8A or 800mA minimum).

The following table shows the dimension of the grounding screw and lug.

Item 1 2 3 4 5 6 7 8
Tolerance W: ± 0.5 d2: ± 0.2 L: ± 0.5 F: ± 0.5 E: ± 0.5 d1: ± 0.2 D: ± 0.2 T: ± 0.5
Size 7.20 4.30 21.50 5.90 13.00 3.40 6.70 1.00

Using the Access Point with Power Adapter

Use a compatible power adapter (Arista SKU: PWR-AP-W5) to power the AP.

Warning - The O-435E AP requires a UL-listed PoE power source suitable for use at 45ºC. The power output should meet LPS requirements or PS2, with a rating of 48V DC (1A minimum). The current supplied by PoE++ should be 850mA. If not using PoE++, ensure that you use only an AC power adapter supported by the AP. The power adapter should be suitable for use at 45ºC. Use this product with a Listed Direct Plug-In Power Unit marked as Class 2, Listed Power Adapter, or DC power source marked L.P.S. (or Limited Power Source) and rated from 12 V DC, 4A minimum.

The maximum altitude of operation for the power adapter is 5000m.

To power up the device with power adapter, perform the following steps:
  1. Plug the power cable into the DC power receptacle on the back of the AP.
  2. Plug the other end of the power cable into an 110V~240V 50/60 Hz AC power source.
  3. The LED lights turn on when ready. Refer to the LED status table.