The configuration guide is no longer being updated. Please refer to the CloudVision Help Center going forward.

Enabling FIPS Mode

To enable FIPS mode, perform the following steps.

Enable FIPS mode during the installation of a new CloudVision cluster by entering yes when prompted with FIPS mode:

For shell-based configuration, the prompt will be included as part of the Common Configuration.
Common Configuration:

CloudVision Deployment Model [d]efault [w]ifi_analytics: d
DNS Server Addresses (IPv4 Only): xxx.xxx.xxx.xxx
DNS Domain Search List:
Number of NTP Servers: 1
NTP Server Address (IPv4 or FQDN) #1: xxxxxxxxxx
Is Auth enabled for NTP Server #1: no
Cluster Interface Name: xxxxx
Device Interface Name: xxxxxx
CloudVision Wifi Enabled: no
Enter a private IP range for the internal cluster network (overlay): xxx.xxx.xxx.xxx
FIPS mode: yes

When doing an ISO-based configuration, you will add yes under the common section of the cvp-config.yaml file. 
Python
Commom:
cluster_interface: xxxxxx
cv_wifi_enabled: 'no'
deployment_model: DEFAULT
device_interface: xxxxx
dns:
 fips_mode: 'yes'
kube_cluster_network: xxx.xxx.xxx.xxxx
ntp_servers:
- auth: 'no'
server:
num_ntp_servers: '1'
node1:
default_route: xxxx.xxxxx
dns_domains:
- sjc.aristanetworks.com
hostname: xxxxxxxxxxx
interfaces:
eth0:
ip_address: xxx.xxx.xxx.xxx
netmask: xxx.xxx.xxx.xxx
version: 2